🛢️ Huron State 44-36 36-25 TF4H

True Oil LLC · McKenzie County, ND · File #43346 · Generated 2026-09-30 07:01

API: 3305310896
Target Formation: Three Forks
Confidence: High

📊 Signals (4)

Tier	Signal	Date	Service Impact
Tier 3	NDIC engineer flags that the well's spacing unit may be subject to a Federal permit, instructing operator to contact the BLM Dickinson office to ensure proper documentation.⏰ TIME-SENSITIVE 📄 Email from NDIC permitting engineer. Introduces a potential federal regulatory hurdle that must be resolved prior to operations, adding a layer of oversight and potential delay.	2026-09-25	General Oilfield Services
Tier 3	Permit approval is conditional on a 150' north/south and 500' east/west setback within the spacing unit, justified by a cemented production liner. Anticollision report shows multiple close approaches with offset wells, requiring collision risk procedures. 📄 Permit stipulations and attached anticollision report. Combines a non-standard, geology-justified regulatory setback with active, multi-well collision avoidance challenges, dictating precise well placement and survey frequency.	2026-09-25	Directional Drilling
Tier 3	Operator declares in a letter that drill cuttings will be taken only to 'Ideal Oilfield Disposal or IHD Solid Management disposal facility'. 📄 Operator statement letter. Explicitly names two approved waste disposal vendors, pre-selecting them for this well and others on the pad, locking in a service contract.	2026-09-08	General Oilfield Services
Tier 3	Operator specifies use of a Halliburton RapidStart Initiator Sleeve for the production liner, which will be fully cemented, eliminating ability to frac out of the shoe. 📄 Cementing and completion details within the drilling program. Identifies a specific, pre-selected completion technology vendor and a deliberate engineering choice that locks in the cementing and stimulation design.	Unknown	Completions / Frac

💡 Operator Intent

To drill a long lateral (~10,195 ft MD lateral section) targeting the Three Forks formation as part of a multi-well pad development.

Well name includes 'TF4H', completion interval targets 'Three Forks Upper', and lateral extends from ~11,300' MD to 21,495' MD.
To manage collision risk with at least 10 existing or planned offset wells on the same pad, requiring precise directional control.

The anticollision report lists multiple offset wells (e.g., Huron State 14-36 36-25 TF1H, B1H, etc.) with separation factors triggering 'Collision Risk Procedures Req.'.
To utilize a fully cemented production liner with a specific initiation sleeve, foregoing the ability to frac out of the shoe.

"Will utilize a Halliburton RapidStart Initiator Sleeve. Will be fully cemented in place with no ability to frac out of shoe."

🔧 Service Operator Relevance

Directional Drilling & Surveying

Anticollision report shows multiple close approaches with offset wells, requiring strict survey frequency (30' in curve, 90' in lateral) and collision risk procedures. The approved permit is conditional on precise placement.

Cementing & Centralizer Services

Detailed cement program specifies large volumes and centralizer counts (~200 solid body centralizers for production liner). The cemented liner with specific sleeve precludes shoe fracturing, making primary cement job critical.

Waste & Cuttings Disposal

Operator has explicitly named two disposal facilities. A leak-proof filter sock container is required on-site from spud through flowback, indicating need for waste handling equipment and services.

Pad Construction & Earthwork

Detailed pad construction plans with cut/fill quantities exist. Operator must contact NDIC inspector prior to location construction, and a perimeter berm with impermeable base is required, indicating imminent site work.